GAS SAVER PRO

INSTALLATION INSTRUCTIONS

 

All Distributor Ignitions:

Install one Gas Saver Pro unit on each of the spark plug wires as close to the distributor as possible.  The arrow on the unit MUST face toward the spark plug.  Be sure that the unit is tightly closed so that there is no slippage of the unit on the spark plug wire.

 

     

installed on 94 Toyota Corolla

installed on 97 Plymouth Breeze

 

Distributor-Less Ignitions:

 

1. Install each Gas Saver Pro over the wires that connect to the individual coils, attaching the unit near to the connector  (see picture)
2. Determine where on the wire the Gas Saver Pro unit will fit without interfering with the positioning of the wires.
3. Cut back any tape or other protecting shielding from the wires (DO NOT CUT THE INSULATION FROM THE INDIVIDUAL WIRES).  Remove ONLY enough shielding so that the unit will fit over the exposed wires.
4. Install the unit over ALL of the exposed wires.  Hold the unit tightly with the wires inserted and make sure there is no movement.  Unit should be tight over the wires.  On systems with less than 4 wires, it may be necessary to cut a 1 inch length of electric copper wire to act as a “filler” to insure that the unit fits tightly without movement when secured.
5. Arrow on unit MUST face the coil and spark plug.

 

installed on 2005 Toyota Avalon

On Ford V-8 engines:

If there is one coil wire set that has only 2 wires, on this cylinder capture only the RED wire, and use “filler” as described above.  All other cylinders: capture ALL the wires inside of the Gas Saver Pro unit.